Dubro Long Super Strength Servo Arm Futaba - 670
or 4 interest-free payments with Afterpay
| Brand | Dubro |
|---|---|
| Type | Servo Arm |
The Dubro 670 long Super Strength servo arm is a heavy-duty replacement output arm for Futaba servos in RC aircraft. Its extra length puts linkage holes further from the centre of the servo, so you can get more control throw, or finer adjustment, than a short stock arm allows.
The Super Strength design is aimed at models where control loads are higher than average, such as larger sport and aerobatic planes, where a flexing arm can cost you precise control. This Futaba servo horn suits builders setting up a new model and pilots replacing worn or broken arms on an existing one. Servo makers use different output splines, so check that your servo takes a Futaba-spline arm before fitting, and set your end points again after changing arm length.
Key Features
- Futaba-spline fitting to suit Futaba servo output shafts
- Long arm length for extra throw on control surfaces
- Several linkage holes along the arm for adjusting throw
- Super Strength construction resists flex under load
- Dubro part number 670
What's Included
- Dubro 670 long Super Strength servo arm (Futaba spline)
What You Need
- Futaba servo with a compatible output spline
- Servo arm retaining screw (normally supplied with the servo)
- Pushrod with a clevis or connector for your control surface